Thingiverse
Anet A6/A8 Belt Spacer
by IALock
1
Downloads
2
Likes
0
Makes
Belt holder for Anet A6/A8
This is a remix
To get an idea of how to install, look at what I remixed this from: https://www.thingiverse.com/thing:1842296 by kaseat
It is essentially the same thing, just cut in half to make it easier to install
DISCLAIMER: This SHOULD work on the Anet A8 in THEORY. I do not own an Anet A8, so thus cannot try it.
Made to create even tension along Y-Axis belt
I couldn't quite get this to work for my printer, but only because I cut my belts too short to m
This is a remix
To get an idea of how to install, look at what I remixed this from: https://www.thingiverse.com/thing:1842296 by kaseat
It is essentially the same thing, just cut in half to make it easier to install
DISCLAIMER: This SHOULD work on the Anet A8 in THEORY. I do not own an Anet A8, so thus cannot try it.
Made to create even tension along Y-Axis belt
I couldn't quite get this to work for my printer, but only because I cut my belts too short to m
Sign in to leave a comment
Sign in