Thingiverse
Lanyard Safety Clip (Can also be used for Medals)
by Goingmad
86
Downloads
74
Likes
0
Makes
A Lanyard or Medal Safety Clip
This will take a 1 inch or 25mm wide ribbon.
Pulling on the lanyard will result in the clip pulling apart so it doesn't get stuck.
Once printed test the pushing together and pulling apart of the two pieces, if still to tight use a piece of sandpaper to rub down the small nodule on the male connector until you get the desired pull apart strength.
Please post a make if you print one, it's always good to see one someone else has made.
This will take a 1 inch or 25mm wide ribbon.
Pulling on the lanyard will result in the clip pulling apart so it doesn't get stuck.
Once printed test the pushing together and pulling apart of the two pieces, if still to tight use a piece of sandpaper to rub down the small nodule on the male connector until you get the desired pull apart strength.
Please post a make if you print one, it's always good to see one someone else has made.
Sign in to leave a comment
Sign in