Thingiverse
CR-10S stock Filament Runout Detection switch holder & cleaner
39
Downloads
33
Likes
0
Makes
the name pretty much sums it up.
uses the 3 existing screws from the run out housing that comes with your cr-10s.
may need drilling a little where the filament guide is to fit the 4mm Bowden Tube perfectly and slide filament with ease.
I used sound proofing foam for the cleaner. you can use any dust free foam you see fit tho.
secures cable with a zip tie.
attaches to the same z-rod screws as the original ((DO NOT OVER TIGHTEN))
((DO NOT SUPER GLUE THE DETECTION SWITCH HOLDER
uses the 3 existing screws from the run out housing that comes with your cr-10s.
may need drilling a little where the filament guide is to fit the 4mm Bowden Tube perfectly and slide filament with ease.
I used sound proofing foam for the cleaner. you can use any dust free foam you see fit tho.
secures cable with a zip tie.
attaches to the same z-rod screws as the original ((DO NOT OVER TIGHTEN))
((DO NOT SUPER GLUE THE DETECTION SWITCH HOLDER
Sign in to leave a comment
Sign in