Thingiverse
electric skateboard case swappable battery inclosure with shell 10s2p
by Malcolm_X
4
Downloads
12
Likes
0
Makes
verry good M_X swappable battery inclosure with shell for 10s2p
you wil need some glue and sandpaper and black 10mm duck tape
don't use hot glue if you use PLA its possible that is warps
on the shell is a cutout for the tape after you glued the lit best is use waterproof
the lit of the batteryshell you need to stick together or remix for screws you like
but the glue and tape is al ready overkil
make sure the the rails under the shell are flush or sanded
if this is not possible remove them
you wil need some glue and sandpaper and black 10mm duck tape
don't use hot glue if you use PLA its possible that is warps
on the shell is a cutout for the tape after you glued the lit best is use waterproof
the lit of the batteryshell you need to stick together or remix for screws you like
but the glue and tape is al ready overkil
make sure the the rails under the shell are flush or sanded
if this is not possible remove them
Sign in to leave a comment
Sign in