Thingiverse
badge pass
by maxball
10
Downloads
11
Likes
0
Makes
My badge for pass.
for card sizes 5.4 mm x 8.6 mm (+/- 0.5 mm)
After printing you may cut openings.
I am left this holes covered for better printing a face side
In this badge there are small latches on each side that do not allow it to open itself.
for card sizes 5.4 mm x 8.6 mm (+/- 0.5 mm)
After printing you may cut openings.
I am left this holes covered for better printing a face side
In this badge there are small latches on each side that do not allow it to open itself.
Sign in to leave a comment
Sign in