Thingiverse
Egg Shaped Speaker
by jongdepaul
77
Downloads
97
Likes
1
Makes
An egg shaped loudspeaker enclosure, designed this with Tinkercad.
The first incarnation fits a pretty much run of the mill 4" (11.5cm) full range driver. I am using a speaker I had laying around collecting dust. It's designed for a full range driver so its easy to wire up and you don't need any filters etc.
Printed in an upright position (no supports needed) with 0.2mm resolution at 5cm/sec which took a good 15 or so hours to do. Its nearly 16cm tall so make sure your printer can handle
The first incarnation fits a pretty much run of the mill 4" (11.5cm) full range driver. I am using a speaker I had laying around collecting dust. It's designed for a full range driver so its easy to wire up and you don't need any filters etc.
Printed in an upright position (no supports needed) with 0.2mm resolution at 5cm/sec which took a good 15 or so hours to do. Its nearly 16cm tall so make sure your printer can handle
Sign in to leave a comment
Sign in