Thingiverse
sisal scratching post stabilization
by JoeGu
38
Downloads
39
Likes
0
Makes
I wanted to stabilize a scratching post a little bit (preventing it from wobbling).
So I created those stabilization item that can be pushed over the post and fixed with screws to the (bottom/top) plate.
The inner diameter is 108mm (for a post with 90mm diameter wrapped with sisal cord).
Printing it with 1.6-2mm and infill with 20-40% should be strong enough in most cases.
I attached it to a 50cm long post (one to the bottom and one to the top plate) and it works well for me.
So I created those stabilization item that can be pushed over the post and fixed with screws to the (bottom/top) plate.
The inner diameter is 108mm (for a post with 90mm diameter wrapped with sisal cord).
Printing it with 1.6-2mm and infill with 20-40% should be strong enough in most cases.
I attached it to a 50cm long post (one to the bottom and one to the top plate) and it works well for me.
Sign in to leave a comment
Sign in