Astro-X Switch Minion/AXII Shark Fin Antenna mount

You must print in TPU for your antenna's to fit. They are simply press fit. The Fin is 35mm high. Use standoff screws for the back and a zip tie to secure the front. I may do a version with relief cuts so you can use ABS/PETG or the like for the fin. There is an artifact near the base of the antenna holder that occured when I made a change during the original design that i was unable to remove. It doesn't impact the print.

Print with flat side down.
With 3D Best TPU and 3 top 3 bottom and 3