RJ4JP-01-08 Igus bearing block for i3 & clones

Igus bearing hole size is 15.2mm after shrinkage it fits 15mm Igus bearing. There is a 1mm gap for clamping pressure applied which is needed for Igus bearings to work properly other wise you will have small amount of wiggle from the bearing on the 8mm smooth rod. Also allows for space on the drive belt side by having a low profile side.

Print using ABS or PETG so there is no deforming if you decide to enclose your printer at a later date. PLA can be used and will work perfectly fine.
Use M4