Bowden X-Carriage Mount for E3D v6 with 40mm Fan and BLTouch

AIR is a Bowden mount for the E3D v6 with a 40mm cold-end cooling fan, 50mm 5015 layer fan and BLTouch bed levelling sensor.

I have included a suitable X-Carriage for the Prusa i3 but feel free to design your own. The mounting hole spacing is 24mm (H) by 23mm (V) center-to-center.

Important: If you print the layer fan duct in the same material you regularly print with then you MUST enable the layer fan when the hot-end is active to prevent warping of the duct.

**What you need**
1x E3D