Thingiverse
Housing for DIY Lab Power Supply
by mdupain
6
Downloads
8
Likes
0
Makes
This is a housing for my DIY Lab PSU.
The PSU is build from a LED Powersupply, a step up/down converter, voltage and current display and some pots and connectors all ordered from aliexpress.
I needed to cut out some of the vins to make a flat surface to mount the pots and terminals properly. Also the gap for the V-A display is slightly to big.
Also it's advised to make some testprints before since sizing needs to be quite precise.
Some part of the design is based on: https://www.thingi
The PSU is build from a LED Powersupply, a step up/down converter, voltage and current display and some pots and connectors all ordered from aliexpress.
I needed to cut out some of the vins to make a flat surface to mount the pots and terminals properly. Also the gap for the V-A display is slightly to big.
Also it's advised to make some testprints before since sizing needs to be quite precise.
Some part of the design is based on: https://www.thingi
Sign in to leave a comment
Sign in