CR-10S Vertical Brace Rev 2

This is my second attempt at a vertical brace for the CR-10s printer. This uses 1/2 inch electrical (galvanized steel) conduit as the brace, cut 2 pieces each to 24 inches. Super cheap at hardware store, about $2.50 for a 5 foot piece. First attempt here: https://www.thingiverse.com/thing:3097456.

This allows full 400mm height usage of the printer (tested!).

I printed these on glass mirror in black PLA at 75C first layer, then 65C. I set infill to 20% but I set the inner/outer wall