Acrobrat - 20x20 Capacitor Mount

This is the Capacitator mount I designed when building my Acrobrat.

https://rotorbuilds.com/build/14408

The sleeve dimensions are 10MM dia x 16MM length. It was designed around this cap from RDQ:

https://www.racedayquads.com/products/panasonic-1000uf-35v-low-esr-capacitor-for-noise-reduction

I used 10-12MM M2 button head screws for the stack mount. Just check your stack accordingly as these will add 3MM.

Also, I nipped out little "notches" from the bottom side of the mount. Onl