MMU2 filament change test

This is just a simple set of 5 adjacent 5x5mm towers 10mm tall. It can be used to stress test the filament change on an Prusa MMU2.

Filament1 lays down a 5x25mm base and should always be used. In your slicer you can bring in 1-2, 1-3, 1-4, or 1-5 to test various numbers of filaments.

I have not printed it yet, planning to use it tonight to start dialing in my Matterhackers Build filament settings.

[added 10mm version. 5mm was a bit too small]