Thingiverse
Bulldog XL++ v1.1 (remix)
by klapauzius
1
Downloads
1
Likes
0
Makes
This is a remix of the Bulldog XL despaghettification accessory by Klaverentwee. Thanks to him/her for sharing this.
Unfortunately it didn't fit to my (early version original) BulldogXL extruder. There are two "feeding screws" (sorry for my bad english) reaching aprox 3mm towards the driving gear, so I had to cut a bit from the original design on both sides.
Picture shows the change in comparison to the original design.
Works fine for me except of the 1.8mm drilling it needed after p
Unfortunately it didn't fit to my (early version original) BulldogXL extruder. There are two "feeding screws" (sorry for my bad english) reaching aprox 3mm towards the driving gear, so I had to cut a bit from the original design on both sides.
Picture shows the change in comparison to the original design.
Works fine for me except of the 1.8mm drilling it needed after p
Sign in to leave a comment
Sign in