Thingiverse
Flat Mouse Trap
by R_3D
4
Downloads
0
Likes
0
Makes
NOTE: updated version, use the V2 body, the original version is still available.
This is a flat mouse trap that I designed and modeled. The only additional components required is a strong rubber band, and 4 screws (about 3 mm in diameter) to hold the trap to any type of container/wall (one screw is also used as a pivot for the trigger).
I printed the trap using Cura, at 0.16mm layer height, and 60mm/s, 100% infill (since it is so small it doesn’t take that much filament), and using PLA.
I p
This is a flat mouse trap that I designed and modeled. The only additional components required is a strong rubber band, and 4 screws (about 3 mm in diameter) to hold the trap to any type of container/wall (one screw is also used as a pivot for the trigger).
I printed the trap using Cura, at 0.16mm layer height, and 60mm/s, 100% infill (since it is so small it doesn’t take that much filament), and using PLA.
I p
Sign in to leave a comment
Sign in