Ribbon Cable mod for Hypercube X-Carriage with Cable Chain

This allows you to replace the bundle of cables going from your control board and PSU etc to the x-carriage (i.e. heater, end-stop, fans, sensor). It uses a PCB at each end with a length of 20 conductor ribbon cable in-between with 20 pin IDC connectors,

Gerber file for the PCB attached, however this is a direct link to the EasyEDA project I created .. https://easyeda.com/alandyoung/3dprinterbreakout

I had 10 of the pcb's made by JLC PCB (https://jlcpcb.com/) for just a couple of $.

**T