Thingiverse
bad dragon and DIT silicone sleeve, adjustable angle desk mount. v2
by kmonster
17
Downloads
18
Likes
0
Makes
It holds your favorite soft shell sleeve so you can use it while watching vids or viewing VR content. :P
The item uses about a 1kg roll of PLA filament.
All parts can be printed with low infill and perimeters due to small triangles set at stress points. almost all breaks can be fixed with application on PLA from a 3d pen, resulting in a stronger point than before.
its highly recommended that you melt edges and round them off.
A printed washer in the middle of the project need to be
The item uses about a 1kg roll of PLA filament.
All parts can be printed with low infill and perimeters due to small triangles set at stress points. almost all breaks can be fixed with application on PLA from a 3d pen, resulting in a stronger point than before.
its highly recommended that you melt edges and round them off.
A printed washer in the middle of the project need to be
Sign in to leave a comment
Sign in