Thingiverse
ID card holder
by db2000
8
Downloads
6
Likes
0
Makes
The little tag on my ID card holder broke. Printed out a little 'hat' for it for fun rather than chasing up for a new one. Probably about the same amount of time either way but this is more enjoyable.
Printed in PLA at 80% infill 0.2mm layer height. Glued the two parts together with JB-Weld original (Epoxy) and also generally glued the lid to the holder.
My particular ID card holder had two little holes in it, the design has two little tabs that go through those holes which locates it.
Printed in PLA at 80% infill 0.2mm layer height. Glued the two parts together with JB-Weld original (Epoxy) and also generally glued the lid to the holder.
My particular ID card holder had two little holes in it, the design has two little tabs that go through those holes which locates it.
Sign in to leave a comment
Sign in