Thingiverse
Tesla Coil - 1/4" Primary Coil Supports (with Strike Ring supports)
by nabzim
29
Downloads
25
Likes
0
Makes
These are the Primary Coil supports which are currently on my Tesla coil.
The design is for quarter-inch copper refrigeration coil, with a pitch of 0.48 inches per turn.
I had to rebuild my primary coil twice over; each time I just glued the new supports on top of the old ones. This was my 3rd and final design.
This is NOT a true flat coil; it is conical, angled 1.5 degrees up from the floor plane.
Before uploading it here, I had added some options for you:
1. Zip tie holes
2. Three di
The design is for quarter-inch copper refrigeration coil, with a pitch of 0.48 inches per turn.
I had to rebuild my primary coil twice over; each time I just glued the new supports on top of the old ones. This was my 3rd and final design.
This is NOT a true flat coil; it is conical, angled 1.5 degrees up from the floor plane.
Before uploading it here, I had added some options for you:
1. Zip tie holes
2. Three di
Sign in to leave a comment
Sign in