Y-Axis Belt Tensioner and Support (Custom Cr-10 Clone)

10/5/18 - Rev2 changes needed, the t-nuts I use were wider than the opening I made on the model, extended it by 6 mm to allow a fit. Should now screw down nicely into the aluminum extrusion.

10/3/18 - Belt simply wouldn't fit while keeping the top fixturing holes in place. Rev2 seems like the only way to fixture it properly. Also thickened up the top posts a little bit as they keep popping off my prints.

Hopefully this works out. Very prelim at this stage. This remix should allow you to us