Thingiverse
Spool holder with bearings
by Geoffree
8
Downloads
2
Likes
0
Makes
A free spinning spool holder (with bearings) for most 1Kg filament spools and below. Minimum diameter of centre of spool is 50mm, maximum width 74mm.
Uses 2 low cost 608zz bearings (as used in many skateboards as well as 3D printers) - OD 22mm x ID 8mm x 7mm width.
Designed in 3 parts - centre roll and 2 identical end caps with the bearings. I've used a M8 x 90mm bolt, screwed into a captive nut (welded) on a metal plate fixed to the side of a cupboard conveniently situated above my printe
Uses 2 low cost 608zz bearings (as used in many skateboards as well as 3D printers) - OD 22mm x ID 8mm x 7mm width.
Designed in 3 parts - centre roll and 2 identical end caps with the bearings. I've used a M8 x 90mm bolt, screwed into a captive nut (welded) on a metal plate fixed to the side of a cupboard conveniently situated above my printe
Sign in to leave a comment
Sign in