Dual Z Axis MKS Sbase 1.3

Using the extruder connector 2 for Z2 axis without splicer

So, you need to make sure that none of the steps, dir and enable configuration values for the slave step motor driver, E1 are present in the configuration file. (Smoothieware)

For example, if you are using E1 as a slave, make sure that none of the following values are present in the configuration file:

extruder2.hotend.step_pin (delete)
extruder2.hotend.dir_pin (delete)
extruder2.hotend.en_pin (delete)


jumper pins JC_M4 a