Thingiverse

Y Axis 60mm Fan Mount

by portoforuit

27 Downloads

11 Likes

0 Makes

Download Model

I initially had a 40mm fan on a heat sink for my motor and that did a good job but it recently died and all I had laying around was a spare 60mm fan. The motor runs a LOT cooler now. After a 6 hour print, I measured the temperature with a laser temp gun at 30C. This is great because I run my Y axis VREF a bit higher than my X.

I'll be replacing this 60mm with a Noctua fan to reduce the noise.

I used only one M3 screw (but you can use two since the mount has two holes) with a washer. The sc

Source

Thingiverse

Comments