Thingiverse
PIR case - 24V model (Loxone)
by Kclemens
5
Downloads
2
Likes
0
Makes
A 2-part enclosure for a 24V motion detector. For corner installation a triangle piece is added.
Because I was printing with PETG, I've added a raft to the front file to prevent corner lifting.
A fresnel has to be added. I take some out of very cheap motions detector I bought in a store nearby. Lenght: 72 mm, height 37mm, thickness 1 mm.
In case you will buy the same PIR sensor to install for a Loxone system: You will have to place a 2k Ohm resistor between VCC & out of the sensor. Invert
Because I was printing with PETG, I've added a raft to the front file to prevent corner lifting.
A fresnel has to be added. I take some out of very cheap motions detector I bought in a store nearby. Lenght: 72 mm, height 37mm, thickness 1 mm.
In case you will buy the same PIR sensor to install for a Loxone system: You will have to place a 2k Ohm resistor between VCC & out of the sensor. Invert
Sign in to leave a comment
Sign in