Thingiverse
Stryfe Alternative Top Rail - V2
by andjoe
36
Downloads
23
Likes
2
Makes
No no no no no no NO!!
After TWO failed prints - raft and no raft - I finally realised that, instead of trying to avoid getting a poor lower surface over supports by risking a poor bed adhesion of a really thin section, the BEST bet was to drop the darned thing on its forward face!
Last 2 pictures show the orientation in my slicer (S3D) and supports generated.
Sometimes the light in my brain illuminates on a very gradual dimmer!
Hopefully THIS time I'll get something I can use and show
After TWO failed prints - raft and no raft - I finally realised that, instead of trying to avoid getting a poor lower surface over supports by risking a poor bed adhesion of a really thin section, the BEST bet was to drop the darned thing on its forward face!
Last 2 pictures show the orientation in my slicer (S3D) and supports generated.
Sometimes the light in my brain illuminates on a very gradual dimmer!
Hopefully THIS time I'll get something I can use and show
Sign in to leave a comment
Sign in