Thingiverse
PM-SW702 / TYWE2S smart plug jig
by ver2go
26
Downloads
18
Likes
0
Makes
Summary:
I purchased some iSelector (SM-PM702) smart plugs to try to flash Tasmota firmware on. I tried to come up with a least intrusive way but in the end you still will need to get to GPIO 1 located in a hard to reach place in the plug.
The jig seems to work, I see the ESP boot loader message from the Tuya firmware.
**This Will not flash a SM-PM702 as is**.
I'm publishing this in case it is of use to anyone and or may want to solder a jumper to GPIO 1. Untested as of now for ac
I purchased some iSelector (SM-PM702) smart plugs to try to flash Tasmota firmware on. I tried to come up with a least intrusive way but in the end you still will need to get to GPIO 1 located in a hard to reach place in the plug.
The jig seems to work, I see the ESP boot loader message from the Tuya firmware.
**This Will not flash a SM-PM702 as is**.
I'm publishing this in case it is of use to anyone and or may want to solder a jumper to GPIO 1. Untested as of now for ac
Sign in to leave a comment
Sign in