Thingiverse
Cube 3 Extruder Hub Clamp
by eldroch
5
Downloads
5
Likes
0
Makes
Major props to MajorOCD for this incredibly useful mod.
Everything worked pretty well for the 2nd extruder, but I couldn't get it secured on the 1st extruder. In both cases, the clips seemed just a little too short. I'm not sure if it was an issue on my part, a printer defect, or if the model didn't account for that tiny 1/10 inch "bump" around the gearing.
I was printing in PLA so I didn't have much wiggle room, so I have stretched both of the clips by about 3mm in order to overcome
Everything worked pretty well for the 2nd extruder, but I couldn't get it secured on the 1st extruder. In both cases, the clips seemed just a little too short. I'm not sure if it was an issue on my part, a printer defect, or if the model didn't account for that tiny 1/10 inch "bump" around the gearing.
I was printing in PLA so I didn't have much wiggle room, so I have stretched both of the clips by about 3mm in order to overcome
Sign in to leave a comment
Sign in