Thingiverse
Tevo Tornado e3D v6 fang mount with BL-touch
126
Downloads
70
Likes
1
Makes
Hotend mount for the e3d v6 on the Tevo Tornado, it might also work with the CR-10 but I did not test that.
I switched from my anet a8 to the tevo tornado and I missed the e3d hotend (I had a e3d v6 on my anet). The printquality of the e3d v6 hotend is just a tiny bit better than the original one.
I used the frame-piece of "DemolitionX" and slightly modified it so you can mount a BLTouch sensor to it. I used the BLtouch mount of "gdramos". So the BlTouch offsets are;
- x=42,5mm
- y=12,5m
I switched from my anet a8 to the tevo tornado and I missed the e3d hotend (I had a e3d v6 on my anet). The printquality of the e3d v6 hotend is just a tiny bit better than the original one.
I used the frame-piece of "DemolitionX" and slightly modified it so you can mount a BLTouch sensor to it. I used the BLtouch mount of "gdramos". So the BlTouch offsets are;
- x=42,5mm
- y=12,5m
Sign in to leave a comment
Sign in