Thingiverse
Filament Pulley
by wozmon
32
Downloads
16
Likes
0
Makes
I designed this pulley so that i could have filament on the table beside my printer rather than on the top as originally designed.
It attaches to the frame with an M4 nut and bolt(i used M5 nuts as spacers as my bolt was too long) using a t-bolt bracket from: https://www.thingiverse.com/thing:2696207
but the 4mm hole in the bracket could be used to attach this anywhere.
The bearing in the middle is using this BB-bearing with a washer on either side, but a 608 bearing would fit too: https
It attaches to the frame with an M4 nut and bolt(i used M5 nuts as spacers as my bolt was too long) using a t-bolt bracket from: https://www.thingiverse.com/thing:2696207
but the 4mm hole in the bracket could be used to attach this anywhere.
The bearing in the middle is using this BB-bearing with a washer on either side, but a 608 bearing would fit too: https
Sign in to leave a comment
Sign in