BetaFPV 65X 300mah 2s Turnigy Nanotech battery holder

I remixed this from the Mobula7 mount by Thump2010 to allow it to secure to the 65x frame and still retain the receiver slot. Weighs 1.27g after removing support material. I am not very experienced with 3d modeling so if you have any suggestions I can try and change or would like to improve on it yourself feel free to.

Installation: Cut the clip part of the print off center as shown in the 1st and 3rd pictures. You can cut down the center but then you will need to lift the stack to install. I