Thingiverse
sg90 to D rod coupler
by JRumkee
6
Downloads
1
Likes
0
Makes
A coupler for the SG90 servo motor so it can drive a D-rod.
D-rod diameter = 3.7mm
gear coupler mesh based on "Printed SG90 Servo Connector by NirDobovizki"
gear mesh size ~4.7mm
gear teeth are very small so you may have to play with settings to get it to print.
( i used .1 )
In addition - i'm no fusion360 expert! the model isn't perfect, use it as a starting point.
D-rod diameter = 3.7mm
gear coupler mesh based on "Printed SG90 Servo Connector by NirDobovizki"
gear mesh size ~4.7mm
gear teeth are very small so you may have to play with settings to get it to print.
( i used .1 )
In addition - i'm no fusion360 expert! the model isn't perfect, use it as a starting point.
Sign in to leave a comment
Sign in