Thingiverse
CR-10 MKS GEN L board / silent TMC2208 + Raspberry Pi mount for Klipper
by stevenfayers
75
Downloads
42
Likes
0
Makes
Mounting plate for MKS Gen L board (RAMPS) and Raspberry Pi to fit into Creality CR-10 control box.
This plate is part of a project to try out Klipper on Creality CR-10. Because the original CR-10 is difficult to flash, and I didn't want to brick the board I bought an MKS GEN L board which is an integrated RAMPS board.
MKS board and A4988 stepper drivers (see update below for silent TMC2208 drivers) were purchased on ebay for a total of £23.
Included here are the steps taken to install.
This plate is part of a project to try out Klipper on Creality CR-10. Because the original CR-10 is difficult to flash, and I didn't want to brick the board I bought an MKS GEN L board which is an integrated RAMPS board.
MKS board and A4988 stepper drivers (see update below for silent TMC2208 drivers) were purchased on ebay for a total of £23.
Included here are the steps taken to install.
Sign in to leave a comment
Sign in