Thingiverse
UM2 Fan Duct with leveling sensor, radial fan and front 30mm fan
by XylenC4
11
Downloads
6
Likes
0
Makes
Attention: Print upside-down! Use support material but make shure there is nothing inside the fan ducts!
YOU WILL LOOSE BUILD-SPACE with this design! Around 10mm on each side of the X-Axis. You will need to print the spacer and put it over the endstop. Otherwhise you will get a suprise on the first time you try to make a homing.
I'll had some issues to get a good cooling solution. I'll did not had stron enough fans [for my other design](https://www.thingiverse.com/thing:3238375) to get sta
YOU WILL LOOSE BUILD-SPACE with this design! Around 10mm on each side of the X-Axis. You will need to print the spacer and put it over the endstop. Otherwhise you will get a suprise on the first time you try to make a homing.
I'll had some issues to get a good cooling solution. I'll did not had stron enough fans [for my other design](https://www.thingiverse.com/thing:3238375) to get sta
Sign in to leave a comment
Sign in