Thingiverse
Mouth Piece
by lilsqueet
1
Downloads
0
Likes
0
Makes
This is a Mouth Piece for the Deadrabbit RDA.
Might need some light sanding where it slides in with the O-ring.
Probably want to print upside down as to not use supports.
Also, if the plastic gets too hot in might smush as it prints so maybe try on a lower temperature, I don't know you know your printer.
Takes a little less than 35 minutes to print.
Edit: Some reason the STL came out on its side. oof.
Edit2: Got time to print today, and I printed on 50% infill and .06 layer heigh
Might need some light sanding where it slides in with the O-ring.
Probably want to print upside down as to not use supports.
Also, if the plastic gets too hot in might smush as it prints so maybe try on a lower temperature, I don't know you know your printer.
Takes a little less than 35 minutes to print.
Edit: Some reason the STL came out on its side. oof.
Edit2: Got time to print today, and I printed on 50% infill and .06 layer heigh
Sign in to leave a comment
Sign in