Breakout PCB - Ultimaker 2 PG35L Direct Drive Extruder for 1.75mm E3D v6 Hotend

After quite a while of using the extruder design by jasonatepaint (https://www.thingiverse.com/thing:1102900), I got the itch to add on to it in order to clean up the wiring. The zip tie that I had strapped around the extruder motor to keep the wires bundled kept sliding back and pushing the heatsink off the motor. After seeing the design of the Wanhao Duplicator 9, I was inspired to consolidate all of the print head wires into a single ribbon cable with a quick disconnect. This also allows for