Rolling Filament Guide part for Led Holder V2 for Anycubic I3 Mega

After the LED Holder V2 (https://www.thingiverse.com/thing:2637201) was finished printing, I found that the Filament would have issues during prints when sitting on the new Filament holder.

It seemed like all filament guides I could find would end up attaching where Part 16 of the LED Holder sits. Not finding a good solution, I found the best looking filament guide I could (https://www.thingiverse.com/thing:2934438) and spend time in Tinkercad mixing Part 16 and this guide.

I know this par