Motor mount for 3DLabprint Slingblade and Racestar 4108

Here is my design of a motor mount for the 3Dlabprint Slingblade.
With this motor mount you can install a Racestar 4108 in your Slingblade.
Propeller 9x6
6S / 1300 mAH LiPo
ESC 40 Amp
Very hot ;-))

There are two versions of the part. One version is for the new building, the other version for retrofitting on the original motor mount.

Print with at least 2 perimeters, 100% infill, layer height 0.2mm and support.

The engine is bolted from the inside. The screw holes must be install