Monoprice Maker Pro Mk. 1 / Wanhao Duplicator 9 Ribbon Cable Holder

This is a simple ribbon holder I made that guides that big fat ugly ribbon cable over the Z-axis assembly. Just feed the cable up into the hole and over the plank, then tie the ribbon down on the lower frame using a ziptie or velcro (might make a clip for that as well).

I made this because I don't like how tight the space is for the ribbon cable between the Z-axis crossbar and the Z-axis frame.

This part will slide right into the aluminum 15 series frame with no screws needed.

Enjoy!