Thingiverse
Pokeball Plus Joystick Extender
by dude2k5
7
Downloads
11
Likes
0
Makes
Decided the joystick on the pokeball plus was too small for my thumb.
So I found a similar joystick extender and modified it to fit the pokeball plus, and made the button much larger. The outside edge is even a little thinner, which allows the light from the LED to show a bit better.
If you have any suggestions, im open to them!
Hope you guys like it
I printed at .1mm-.2mm, 20%-50% infill WITH supports
Should take less than 30 minutes!
Small GIF of the light around the ring
So I found a similar joystick extender and modified it to fit the pokeball plus, and made the button much larger. The outside edge is even a little thinner, which allows the light from the LED to show a bit better.
If you have any suggestions, im open to them!
Hope you guys like it
I printed at .1mm-.2mm, 20%-50% infill WITH supports
Should take less than 30 minutes!
Small GIF of the light around the ring
Sign in to leave a comment
Sign in