Thingiverse
LP-E10 Canon Battery Cap with Labels
by danielbis
7
Downloads
8
Likes
1
Makes
These battery caps help protect your batteries from shorting out and help you keep them organised.
There are two caps, one says 'Full' and one 'Flat'. I printed one in blue and the other in red to help distinguish them.
I used PETG filament because it is slightly bendable, helping for a snug fit. I'm not sure how PLA would cope with it.
It took around 45-50 minutes to print at 0.1mm and 20mm/s. Faster speeds or greater layer heights may make the text less readable and my PETG tends to
There are two caps, one says 'Full' and one 'Flat'. I printed one in blue and the other in red to help distinguish them.
I used PETG filament because it is slightly bendable, helping for a snug fit. I'm not sure how PLA would cope with it.
It took around 45-50 minutes to print at 0.1mm and 20mm/s. Faster speeds or greater layer heights may make the text less readable and my PETG tends to
Sign in to leave a comment
Sign in