Thingiverse
MTD Pan/Tilt Mount Plate
by rx-midget
5
Downloads
5
Likes
0
Makes
This is a mounting plate to cleanly install the PROPAN2 from FPVGadgets.com on the nose of the MyTwinDream (MTD).
Mounting ears on the PROPAN2 need to be cut off to cleanly fit into the mount. These ears will not be needed as the PROPAN2 is secured to the mounting plate with the 4 screws used to hold the frame together.
A Template is included so you can mark the area to cut out to fit the assembly in the nose. Position template with rear lip facing down and against the rear edge of the f
Mounting ears on the PROPAN2 need to be cut off to cleanly fit into the mount. These ears will not be needed as the PROPAN2 is secured to the mounting plate with the 4 screws used to hold the frame together.
A Template is included so you can mark the area to cut out to fit the assembly in the nose. Position template with rear lip facing down and against the rear edge of the f
Sign in to leave a comment
Sign in