Angled 2040 bowden tube support holder

swapped my Tronxy X5s to direct drive and needed a way to support the bowden tube used as a filament guide but also wanted it at a bit of an angle so the tube didn't droop in a bad place on my printer.. Also, I wanted it to holder better than just sitting there without pinching the tube to the point of deforming so I used a tip from one of Maker's Muse's recent videos to make the hold slightly sprint loaded. Works great for me.

Maker's Muse video
https://www.youtube.com/watch?v=j6508J94VsA