Thingiverse
Straw air rotor - school experiment on compressed air thrust
by Depronized
14
Downloads
17
Likes
0
Makes
A simple experiment, print the STL called "Straw Rotor Build Plate.stl" using 0,15-0,2mm layer height, 100% infill and 2-3mm brim.
Cut a 5mm diameter soda straw in 3 pieces, press the rotor onto the hub and make sure it can rotate freely. Insert the three straw pieces and place the "jets" on the outer edges. Rotate them so they don't point in the same direction. Blow in the center straw and watch it rotate!
This was a request from a techer. There are a number of instructions on how to do
Cut a 5mm diameter soda straw in 3 pieces, press the rotor onto the hub and make sure it can rotate freely. Insert the three straw pieces and place the "jets" on the outer edges. Rotate them so they don't point in the same direction. Blow in the center straw and watch it rotate!
This was a request from a techer. There are a number of instructions on how to do
Sign in to leave a comment
Sign in