Thingiverse
Knurling for Lathe
by ANicolai
85
Downloads
56
Likes
0
Makes
The 01-support part I created more for reference. If possible, make metal, steel or aluminum.
The hole should be threaded to M6.
The two rods with pin lock washer for the knurl wheel I made in the lathe, but you can use two 3/16 x 25mm screws.
(The knurl wheel I had here was a 16x8mm with 5.7mm hole. Unfortunately M6 bolt does not fit in the hole).
Glue the M5 bar on the Knob with cyanoacrylate.
You will also need:
2 Screws M6 x 25mm
2 M6 nuts
1 Screws M6 x 20mm
1 Threaded bar M5 x 80
The hole should be threaded to M6.
The two rods with pin lock washer for the knurl wheel I made in the lathe, but you can use two 3/16 x 25mm screws.
(The knurl wheel I had here was a 16x8mm with 5.7mm hole. Unfortunately M6 bolt does not fit in the hole).
Glue the M5 bar on the Knob with cyanoacrylate.
You will also need:
2 Screws M6 x 25mm
2 M6 nuts
1 Screws M6 x 20mm
1 Threaded bar M5 x 80
Sign in to leave a comment
Sign in