Thingiverse
ZOHD DART XL motor mount
by Shikra
10
Downloads
3
Likes
1
Makes
This is an easy print replacement motor mount for the ZOHD DART XL.
The original is only supported by the bottom half with some less than optimal glue so it will come off like mine or flex.
This is a little more solid and has a short stabilising tube that prevents the flexing.
Glue the rear flush with the foam and run some glue down where the tube fits into the foam channel to provide the extra support.
I print at 40% for a very tough stable mount, but anything over 25% probably OK.
The original is only supported by the bottom half with some less than optimal glue so it will come off like mine or flex.
This is a little more solid and has a short stabilising tube that prevents the flexing.
Glue the rear flush with the foam and run some glue down where the tube fits into the foam channel to provide the extra support.
I print at 40% for a very tough stable mount, but anything over 25% probably OK.
Sign in to leave a comment
Sign in