Thingiverse
2020 Profile Spool Holder
by Lqkas
20
Downloads
22
Likes
0
Makes
Spool holder I designed for holding my spool in a way where the natural curve of the filament would go up into extruder and over to hotend.
Should fit any 2020 profile, but was designed for my Tronxy X5S as shown in photos.
It is made so the holder is detachable from the arm, so one can use a spool with a smaller centre hole than 25mm. (flashforge filament for example)
Holder can be put on either side of the arm, in case you have a mirrored printer from mine.
Necessary hardware:
- Mo
Should fit any 2020 profile, but was designed for my Tronxy X5S as shown in photos.
It is made so the holder is detachable from the arm, so one can use a spool with a smaller centre hole than 25mm. (flashforge filament for example)
Holder can be put on either side of the arm, in case you have a mirrored printer from mine.
Necessary hardware:
- Mo
Sign in to leave a comment
Sign in