Thingiverse
Geeetech A10M Bed Clip v2
by fishku
220
Downloads
129
Likes
2
Makes
This is a bed clip to replace the metal clips that come with some Geeetech printers.
The problem is that the metal clips can cause a short circuit on the underside of the heated bed when they scratch away the paint.
By using these bed clips, you eliminate the problem of short circuits.
This is a newer version than my previous bed clip. The issue I had was that the clip would not offer enough grip after a few prints. The reason was that the "springy" part would get too close to the heat be
The problem is that the metal clips can cause a short circuit on the underside of the heated bed when they scratch away the paint.
By using these bed clips, you eliminate the problem of short circuits.
This is a newer version than my previous bed clip. The issue I had was that the clip would not offer enough grip after a few prints. The reason was that the "springy" part would get too close to the heat be
Sign in to leave a comment
Sign in