Slicer Discord
32mm Bottle Trap – 3D-printbaar model van Thingiverse Thingiverse

32mm Bottle Trap

door MaleXLR
22 Downloads
16 Likes
0 Makes
Model downloaden
In all honesty theses drainage traps are quite unique to our needs and may be of no use to anyone else, except perhaps to steal ideas or concepts.

Our caravan [Which you would assume would be self contained] needed a New Zealand approved “blue sticker” to gather revenue, prove that it was self contained and try to dissuade freedom campers from coming to our country – despite investing heavily in advertising us as a tourist destination. Apparently we only want tourists with lots of money… Rant over!

I didn’t want to pull out the poxy, small diameter flexible pipework and clearances at each location for the sink, shower and basin were, annoyingly, slightly different. The final installation was done with 32mm ID PVC pipe and required standard threaded connectors and washers between the traps and the PVC pipe. Since then I had wondered about adapting the threaded connector from my previous post [32mm Union] and making that fit, but that is just a flight of fancy at the moment as all
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Min. bedgrootte
50 mm (Klein)
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie