Thingiverse
Z Axis Anet A8 Anti-Wobble - No extra parts needed!
by Bebon901
3
Downloads
5
Likes
0
Makes
No supports required, just print with the largest end base down. You may want a raft/brim to print if you do not have an adhesive bed.
you put the thin end in the hole above the z axis bar and then slot the bar in the large hole, secure the swirly bar in place by tightening the hexanut screws at the bottom.
USE ZWOBBEL
you put the thin end in the hole above the z axis bar and then slot the bar in the large hole, secure the swirly bar in place by tightening the hexanut screws at the bottom.
USE ZWOBBEL
Sign in to leave a comment
Sign in